How do I reset my APC default settings?

Locate the APC network management interface on the back of your APC UPS. Press the reset button for 20 seconds. Wait for the network led change to the orange color. The APC UPS network management interface will reset its configuration back to the factory default.

How do I reset APC UPS?

Solution: To reset the network interface of a SMT, SMTL, or SMX model UPS, on the display interface hold the UP and DOWN buttons simultaneously for 5 seconds. The display flashes to indicate that the network interface has restarted.

How do I reset my APC User Name and password?

Press the Reset button a second time immediately while the LED is rapidly flashing – which will cause the LED to then go off – in order to reset the User Name and Password to their defaults temporarily (the default User Name and password are both apc).

How do I set up APC UPS?

Connect to the UPS/device serial port using the correct APC configuration cable….9600 bps, 8 data bits, no parity, 1 stop bit, and no flow control.

  1. Apply the port settings to establish the connection.
  2. Press enter 3-5 times to display the username prompt.
  3. Use the default username and password of “apc”.

What is the default login for Schneider Electric UPS?

The default user name is device, and the default password is apc.

What is the default username and password for apc PowerChute?

However, while there is no default username and password for the PowerChute Business Edition Agent 8.0. 1, you can easily reset it by uninstalling and installing the application again.

How do you reboot a UPS?

Turn off the UPS: press and hold the On/Off button until the UPS beeps, then release the button. Disconnect the UPS from the AC outlet. 3. Reconnect the UPS to a functioning AC outlet.

What is the default password for Schneider Electric UPS?

What is the default username and password for APC PowerChute?

What is the default User Name and password for apc PowerChute?

How do I log into apc?

APC: First-time login to an APC device

  1. Configure your PC using a static IP address on the 192.168.
  2. Open a web browser and enter the default IP address of the AP device—192.168.2.66:
  3. Once the login page is loaded, enter the default administrator login information (login: admin; password: admin01) and click Login: