How do I fix Mecha error?

Follow the steps below to troubleshoot if the unit not responding properly or displays MECHA ERROR or MECHANICAL ERROR.

  1. Remove any CDs or tapes from the unit.
  2. Turn off the unit.
  3. Unplug the AC power cord for 15 seconds.
  4. Ensure the recommended speakers are attached properly and that the wires are not shorted.

How do I reset my Sony home stereo?

Resetting the system

  1. Disconnect the power cord and confirm that the STANDBY indicator is not lit. Then reconnect the power cord and turn on the system.
  2. At the same time, press and hold the FUNCTION and ON/Standby buttons until RESET appears on the display window.

How do I factory reset my MHC v71?

  1. Unplug and plug back in the power cord, then turn on the system.
  2. At the same time, press and hold the STOP and Folder – (minus) buttons until RESET appears on the display window.

How do I use Sony VAC aux?

Turn the power off on the portable device. Turn the volume down on the car stereo. Connect one end of a connecting cable to the Headphone or Line out jack on the portable audio player. Connect the other end of the connecting cable to the AUX jack on the car stereo.

What does Error 3 mean on CD player?

Sometimes, these players can act up. If they do, they will usually show an error code. Error code 3 means a mechanical error concerning the laser lens and around the lens, which can be fixed through troubleshooting.

What does CD error mean?

What this means is that the CD player, for some reason, does not recognize the disc. There are various reasons for this error, from the CD lens eye being dirty to a CD format that is incompatible with the player.

How do I reset my Sony MHC vo2?

Home Audio SystemMHC-V02

  1. Unplug the AC power cord (mains lead) from the system, then plug it back in.
  2. Press (power) to turn on the system.
  3. Hold down GUITAR and MEGA BASS for about 3 seconds. [RESET] appears on the display. After the reset completes, the system automatically reboots. Press (power) to turn on the system.

How do I reset my Sony MHC speaker?

Home Audio SystemMHC-V42D

  1. Unplug the AC power cord (mains lead) from the system, then plug it back in.
  2. Press (power) to turn on the system.
  3. Hold down GUITAR and MEGA BASS for about 3 seconds. [RESET] appears on the display. After the reset completes, the system automatically reboots. Press (power) to turn on the system.

How do I reset my speakers to factory settings?

To perform a Factory Reset:

  1. Press the Volume “–” and Power buttons simultaneously and hold for at least six seconds.
  2. You’ll hear a tone that indicates the reset was done and your speaker then should turn off. This reset will bring your speaker back to factory settings.
  3. Turn your speaker back on using the Power button.