Where should curtain holdbacks be placed?

Hang each tieback hook a third of the way up from the bottom of the curtain. Buffer three inches from the edge of the window. For example, if your curtain is 84 inches long, you would place the tieback about 28 inches from the bottom. A tieback for a 36-inch long cafe curtain would be placed 12 inches from the bottom.

How high do curtain tie backs go?

To achieve proper placement, again measure the length of the curtains and divide by three. Hang each tieback a third of the way up from the bottom of the curtain. If, for example, the drape is 100 inches long, you would place the tieback 33 inches from the bottom.

Where should curtain rod brackets be placed?

Each bracket should be placed at the height you previously determined and about four to six inches from the side of the window frame. (This will allow you to open the curtains completely.) Check to make sure your pencil marks are level otherwise the entire window treatment will be crooked.

Where should curtain rods be placed?

Your best move is to hang curtains within 8 inches of the top of the window frame. For very tall windows, which are popular in many modern homes, that means placing the rod as close to the ceiling as possible—in fact, you might want to install rods designed to actually hang from the ceiling.

How far should a curtain rod go past the window?

As a general rule, drapes will be open during the day, so make sure the curtain rod extends at least four inches on each side of the window’s inside frame. To create the illusion of a wider window, extend the rod up to 10 inches beyond the window’s frame.

How far apart can curtain brackets be?

Over 96 inches, a third rod bracket is required as a center support; this is mandatory! Having said that, a 2 inch or 3-inch diameter pole can span a distance up to a full 12-feet without flexing or bowing using only two end brackets.

How far should curtain rod be from side of window?

four to 10 inches
The standard distance from the window casing to the end of the curtain rod (excluding finials) on each side of the window should be four to 10 inches. As a general rule, drapes will be open during the day, so make sure the curtain rod extends at least four inches on each side of the window’s inside frame.

How high should I hang my curtain rod?

How High to Hang Curtains. A rule of thumb (from Architectural Digest) is that curtains should be hung between four to six inches above the window frame, so install your curtain rod accordingly. When you hang the curtain rod high, it will make the window appear taller.

How far apart should drapery hooks be?

I like to space ring clips approximately four inches apart so that there is a handsome fold between each clip in the drapery panel. Start by clipping each end of the panel. Next, clip the middle. Finally, space the clips evenly apart as close to 4 inches as possible.

How many curtain hooks do I need?

To calculate how many you need, divide the length of the curtain rod in inches by the spacing you want. If you want rings every 5 inches on a 10-foot curtain rod, you’ll divide 120 by 5 to get 24, which means you’ll need about 24 rings total.

What is the proper placement of curtain rods?

Wall-mounted rods are usually installed four inches above the window. To find your ideal placement, measure down from the ceiling to the top of the trim at the left corner of your window; mark the midway point.

How do you make tie backs for curtains?

Wooden Beads on a Rope. Start with a rope and add some wooden beads.

  • Rose Vines. This curtain tieback look like a sweet vine of roses.
  • Fabric Bow.
  • Star Tieback.
  • Silver Ropes.
  • Knotted Rope.
  • Simple Bow.
  • Decorative Ribbon.
  • Shell Tassel.
  • Cord Covers.
  • How to make curtains tie backs?

    Pull back each curtain and hold it in the position that indicates where you plan to install the curtain tieback.

  • Add 1 inch to the measurement of the looped tape measure.
  • Place the fabric on a folding cutting board.
  • Where to place tie backs for curtains?

    Measure from the bottom of your curtains to the rod they are hanging on. Divide this number by three.

  • Determine what look you want for your window treatments.
  • Remove your drapes,with the rod,from the window and set them aside.
  • Mark the location for your metal tie back based on the one-third or two-third rule on the wall.
  • How to install curtain holdbacks?


  • Level
  • Tape measure
  • Stud finder (optional)
  • Drill with masonry bits
  • Drywall anchors (optional)
  • Hammer
  • Screws
  • Screwdriver