Where is the fuse for a 2006 Chevy Silverado?

Where is the fuse for a 2006 Chevy Silverado?

On Silverado’s and Sierra’s the engine fuse box is located on the right side of the engine bay when facing it, close to the top right corner.

Where is the reset button on a 2006 Chevy Silverado?

Looking for the 2006 Chevy Silverado fuel pump reset switch may be a little difficult but nothing too bad. This can be found on the toe-board in the passenger-side footwell which is located to the right of the transmission hump. It will be a small round red button.

Where is the tail light fuse located for 2006 Chevy Silverado?

The 2006 Chevy silverado tail light fuse is located inside the fuse box, inside the drivers side of the engine compartment.

Where is the fuse for the trailer lights on a 2006 Chevy Silverado?

Expert Reply: The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo).

How do you reset the engine oil life on a 2006 Chevy Silverado?

If the engine is not running, put the vehicle in neutral and press the gas pedal three times within five seconds to get it to the floor. Three times, the oil change light on the dash should flash, and then it should turn off, indicating that the oil change has been reset.

Where is the fuse for the brake lights on a 2005 Chevy Silverado?

The tail light fuse on Your Chevy Silverado is located in the fuse panel that is under the driver’s side of the dash in the driver’s footwell.

What fuse controls trailer lights Chevy Silverado?

The fuses that control the trailer lights are in slot Nos. 14, 15, 16 and 17. Pull each fuse out, using the puller, and inspect the metal strip within the plastic casing. If it is burnt or broken, install a new fuse with an identical amperage rating.

Is there a fuse for trailer lights?

If you’re problem was turn signals then simply look for the trailer RT or LT fuse and simply replace if needed. This will solve the problem of brake lights also, as they are the same fuse.