When did Hayward buy Goldline?
August 2004
Hayward® Industries, Inc., acquired Goldline Controls® in August 2004. The joining of Goldline and Hayward provides pool owners the first single source of the total pool management system, including pumps, filters, heaters, cleaners, lighting, salt chlorination and pool and spa automation.
How much does Hayward OmniLogic cost?
How Much Does it Cost? Hayward OmniLogic installations can start at $2,800.00 and run upwards of $4,500.00 depending on added accessories.
How do you reset Aqua Logic?
Press the ‘Menu’ until, ‘Default Menu’ appears on the display. This menu is where the ‘Inspect Cell’ message is stored. Press the (>) key, repeatedly, until ‘Inspect Cell, Hold + to reset’ appears on the display.
How do you troubleshoot a Hayward chlorinator?
How to Troubleshoot a Hayward Chlorinator
- Four Hayward Models.
- Chlorine Concentration in the Pool Is Too Low.
- The Lid Is Hard to Tighten or It Leaks.
- The Control Valve Is Clogged.
- The Chlorinator Has an Air Lock.
How do you reset the check light on a Hayward?
You must reset the system by entering the ‘Diagnostic Menu’ and then hitting the right arrow key once and then pushing the plus key once. This should reset the light and message.
How do I reset my Hayward Aqua Plus?
How much is an automation system for a pool?
$1,800 to $4,000
Pool automation systems can be less expensive than many other pool features and accessories. A pool automation system can cost anywhere from $1,800 to $4,000.
How do I reset my Hayward Goldline salt?
Reset AquaRite Salt Chlorination Inspect Cell Light If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.
How do I reset my Hayward chlorinator?
Turn Salt System Off and On With the pump running, take the power switch down to the “Off” position, and then back up to “Auto”. You should hear a click within 10 or 15 seconds. When you do, press the diagnostic button five times in a row. The system will go through a recalibration process.