What fluid goes in Ford F150 transfer case?

What fluid goes in Ford F150 transfer case?

Ford Full Size 4×4 Transfer Case Fluids

What fluid goes in a Ford transfer case?

Recommended for use in the following applications: MERCON®V, MERCON®, DEXRON®-III, DEXRON®-II, Caterpillar TO-2, Allison C-4. Other applications include Power steering fluid where a DEXRON® or MERCON® fluid is recommended.

What type of transmission fluid does a 2006 Ford F 150 use?

The type of transmission fluid the 2006 Ford F-150 uses is Dexron/Mercon. The transmission fluid needs to be replaced every 30,000 to 60,000 miles.

What is Motorcraft transfer case fluid equivalent?

Ford has replaced it with Mercon LV. *XL-12 Transfer Case Fluid has been discontinued by Motorcraft® and replaced by Mercon LV. As of May 2019 an old Motorcraft web page still listed Mercon LV as Not For Use in Transfer Cases, but the most recent LV page specifically states LV is now for all transfer cases.

Is transfer case and transmission fluid the same?

Most transfer cases are filled with an automatic transmission fluid, which is usually red in colour. Others use a thicker gear oil, and some use a specialized fluid that is specifically made just for that transfer case.

How often should you change transfer case fluid f150?

Every 3000 miles
Every 3000 miles or 3 months, whichever comes first Check the transfer case lubricant level (4WD models)

How much transmission fluid does a 2006 f150?

Transmission Fluid Change

What kind of transmission fluid does a 2005 Ford f150 take?

Mobil 1 Synthetic Automatic Transmission Fluid Dexron/Mercon 1 Quart.

What is Mercon LV compatible?

Regarding compatibility, Mercon V is a good match with Type CJ and Type H fluid. At the same time, Mercon LV leaves no stone unturned in meeting the demands of modern transmissions. And coming to compatibility, Mercon LV goes well with older specifications of GM Dexron.

What is equivalent to Mercon LV?

Dexron® VI
Dexron® VI/Mercon® LV Automatic Transmission Fluid is a premium quality, fully synthetic, multi-vehicle, low viscosity automatic transmission fluid that is recommended for use in those General Motors and Ford vehicles that specify the use of Dexron® VI and Mercon® LV fluids respectively.

What type of fluid goes in a transfer case?

The transfer case is always working, whether you use the four wheel drive on your vehicle or not. In the old days, transfer cases were filled with gear oil or automatic transmission fluid (ATF), but some modern transfer cases take specialty lubricants.

What kind of fluid to use in transfer case?

– Secure the vehicle on a level surface. – Locate the oil fill plug on the transfer case. – Remove the top oil fill plug. – Using a flashlight, check for oil at the fill plug hole. – With the top oil fill plug still out, remove the bottom oil drain plug to drain the oil into an oil drain pan.

Do you need to put fluid in the transfer case?

The fluid in the transfer case serves as both lubricant and helps to keep the internal components cool and turning smoothly. Replacing this fluid at appropriate intervals can help prevent premature wear and damage caused by contaminated or broken-down fluid. Additionally, if the transfer case fluid level is low, the entire transfer case should be inspected for leaks and damage. Many mechanics (and some manufacturers) recommend that you replace the transfer case fluid at least every 30,000 miles.

What kind of fluid goes in a Ford transfer case?

Ford Full Size 4×4 Transfer Case Fluids. Similarly, what kind of fluid do you put in a transfer case? FLUID RECOMMENDATIONS Conventional transfer cases require SAE 80W or SAE 80W-90 GL-5 gear lubricant. Full time systems use SAE 10W-30 or 10W-40 engine oil. Conventional transfer cases require DEXRON®II transmission fluid.