What are the symptoms of a faulty slave cylinder?
Symptoms of a Bad Clutch Slave Cylinder
- Inability to switch gears.
- Low fluid level.
- Leaking of brake fluid.
- Clutch pedal goes all the way to the floor before working.
- Clutch pedal feels loose.
- Contaminated brake fluid.
How much is a slave cylinder for a Ford Ranger?
between $368 and $439
The average cost for a Ford Ranger clutch slave cylinder replacement is between $368 and $439. Labor costs are estimated between $269 and $339 while parts are priced at $99.
How do you remove a slave cylinder from a Ford Ranger?
Place a jack under the Ranger and lift it up. Depending on your height, the Ranger should be between 3 to 4 feet higher than normal. Crawl underneath the truck and remove the hydraulic line from the slave cylinder by twisting it counterclockwise and pulling it off.
What happens when slave cylinder fails?
If the clutch slave cylinder develops any sort of leak internally or externally it may cause the pedal to feel spongy or mushy. The pedal may also sink all the way to the floor and stay there when depressed, and may not be able to properly disengage the clutch so the transmission can be safely shifted.
How much does it cost to replace a slave cylinder?
The average cost for clutch slave cylinder replacement is between $206 and $245. Labor costs are estimated between $110 and $138 while parts are priced between $96 and $107. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.
How much does it cost to replace a clutch on a Ford Ranger?
between $824 and $933
Ford Ranger Clutch Replacement Cost Estimate. The average cost for a Ford Ranger clutch replacement is between $824 and $933. Labor costs are estimated between $383 and $483 while parts are priced between $441 and $449.
How long does it take to replace a slave cylinder?
To replace both cylinders takes roughly 8 hours. You can get an exact quote, both as to labor and parts, by using YourMechanic’s on-line estimator for clutch repairs.
Can a slave cylinder fail without leaking?
Can slave cylinder fail without leaking? Yes master cylinders can fail without leakage, the clutch master cylinder has a piston inside and there are separate channels for hi-pressure line and return(low pressure) line and their location in the cylinder differs for manufacturers.
What are the cylinder numbers on a Ford Ranger?
P0302 is certainly a cause for concern, and can be a threat to the drivability the Ford Ranger. The nice thing about it is that the P0302 has tracked the problem to a particular cylinder, which makes diagnosing the problems simpler than P0300, which means that the cylinders are randomly misfiring. It will often be accompanied by codes P0301 -P0308.
How to diagnose the hydraulic clutch on a Ford Ranger?
– still air in the line. Small chance but can try bleeding again – Bad slave. Would need to pull tranny (I am a mechanical engineer and whoever designed this should be punished) – Bad clutch??? Doesn’t seem like it should be though. – Any other ideas??? If I do have to pull the tranny, anything else I should do while I’m there from a reliability standpoint?
How to replace a clutch slave cylinder?
Grab your creeper and go under the vehicle. Install the clutch slave cylinder to the transmission mount.
How to bleed a Ford Ranger clutch master cylinder?
Raise the Ford Ranger about 6 inches off the ground with a jack. You can drive the truck on ramps if you have them.