How do you run a diagnostic test on a Maytag Neptune washer?

I checked the diagnostic code using the following procedure:

  1. Plug the washer in for power.
  2. Put the washer into “Service Mode” by holding the “Delicates” and “Heavy soil” keys simultaneously for 3 or more seconds.
  3. Pushed “Presoak” to put it in diagnostic code mode.

Where is the reset button on Maytag Neptune washer?

How to Reset the Sequence for a Maytag MAH5500BWW

  1. Locate the “Off” button, located to the right of the Neptune’s “Start/Pause” button.
  2. Press the “Off” button within the first 30-seconds of beginning the cycle to cancel the current cycle.

How do you take apart a Maytag Neptune?

This requires one more disassembly procedure.

  1. Remove the back panel of the dryer by loosening the four 5/16-inch screws.
  2. Disconnect the heater assembly by removing the two 1/4-inch screws holding it. Pull the heater assembly out and set it aside.
  3. Lift the drum assembly and pull it out from the back of the dryer.

Why is my Maytag washer not draining or spinning?

If the washer won’t drain or spin, either something is stuck in the washing machine drain hose or pump, or the pump is broken.

Is there a reset button on Maytag washer?

Power/cancel reset Another method for resetting your Maytag washer is to press the Pause/Cancel button, then select the appropriate cycle, and then press the Start/Pause button. This method works best when trying to move the washer onto the next cycle or when trying to clear an error code.

Does a Maytag washer have a reset button?

The Maytag washer doesn’t have a reset button. If you need the reset button, you have to use the ‘Power/Cancel’ button. Push it to stop the current cycle. Select a new cycle and then press ‘Start/Pause.

What is a wax motor on a washing machine?

Some front load washing machines use wax motors to engage the door lock assembly. When a cycle is started, an electrical current is supplied to the wax motor, pushing a pin outward and locking the door. When the wax motor fails, the door lock will not engage and will not allow the machine to spin.