How do I fix code P0016?

How to fix a P0016 OBD-II code?

  1. Repair the wiring or connections to the components, including the camshaft sensor or camshaft OCV.
  2. Check the timing chain and guides and replace if needed.
  3. Replace the camshaft OCV for bank 1 exhaust camshaft.

Where is the crankshaft position sensor on a 2004 Chevy Trailblazer?

If your 2994 Chevrolet Trailblazer has a 6cyl engine the crankshaft position sensor is located on the left side of the engine toward the rear just above the oil pan. On a V8 the sensor is located in the lower part of the timing cover.

Where is the camshaft position correlation Bank 1 sensor A?

The “A” Indicates the Intake Camshaft, located to the intake side of the Cylinder Head. “Bank 1” denotes the Engine Bank that contains the Number One Cylinder.

What could cause a P0016 code?

When the PCM issues a code P0016, the car may be experiencing one of these issues: Stretched or damaged timing chain or timing belt. Damaged camshaft or crankshaft reluctor wheel. Bad crankshaft sensor.

Can you drive with P0016 code?

Diagnosis: This trouble code can cause the vehicle to be hard to start and run rough. In some cases, the vehicle may not be driveable. It should be addressed as soon as possible.

Where is the speed sensor located on a 2004 Chevy Trailblazer?

The vehicle speed sensor is located on the passenger side of the transmission on the tail housing. Check the sensor wire connector to ensure it is connected and secure and not damaged in any way. The sensor should be checked next. There are other possible causes, but start there.

How do you relearn a crankshaft sensor without a scanner?

  1. Turn off all of the accessories.
  2. Accelerate the vehicle to 55 mph at part throttle.
  3. Cruise at 55 mph for another 5-6 minutes.
  4. Decelerate to 45 mph without using the brakes, and maintain 45 mph for 1 minute.
  5. Perform 4 deceleration cycles, without using the brakes, of 25 seconds each where no specific speed is necessary.

Can I drive with P0016?

Repair Urgency: Fix this code immediately (same day if possible) to avoid internal engine damage. Diagnosis: This trouble code can cause the vehicle to be hard to start and run rough. In some cases, the vehicle may not be driveable. It should be addressed as soon as possible.

How much does it cost to fix P0016?

But if the problem has something to do with a broken timing chain, timing belt, and/or tensioner, you can expect to spend around $200 for parts and labor depending on the make and model of your vehicle. The mechanic will also check the cam and crank patterns to rule out a broken sensor or tone ring.

Where is a speed sensor located on a Chevy Trailblazer?

The vehicle speed sensor is located on the passenger side of the transmission on the tail housing. Check the sensor wire connector to ensure it is connected and secure and not damaged in any way.

Where is the speed sensor on a 2003 Chevy Trailblazer?

The 2003 Chevy trailblazer speed sensor can be found on the drivers side of the transmission housing just behind the firewall.

What does p0016 mean on a Chevy Trailblazer?

P0016 is know to occur in the Chevy Trailblazer when the Crankshaft Position Sensor and the Camshaft Position Sensor are out of alignment by a certain number of degrees, or if there is a sensor issue. We’ll explore the symptoms and causes directly below. P0016 refers to which camshaft position sensor is out of time with the Crankshaft.

What causes a p0016 code on a cam sensor?

One of the most common causes of P0016 in any vehicle is going to be wiring issues. You’ll want to inspect the wiring harness for visible damage. A lot of the harness leading to and from the Crank/Cam sensors is going to be exposed to hot exhaust and vibration.

What causes a p0016 to throw out?

The timing chain or belt will throw cause P0016 to throw. This will happen when it has stretched or jumped a tooth or two. If it jumps more than a few teeth, the odds are that the engine itself will not run at all.

What causes a Chevy Trailblazer engine to not run?

The crank and cam sensors work in tandem to produce the ideal air/fuel ratio for your engine. When this timing is off, the engine will typically not run (or barely run) Here are the major symptoms of P0016 in the Trailblazer: Here are the most common causes of P0016 in the Trailblazer, as well as diagnostic advice, and resources to further explore.